SIMULATION OF PARALLEL WORK OF ASYNCHRONOUS GENERATORS IN AUTONOMOUS INSTALLATION FOR CHARGING BATTERIES
Abstract
Using autonomous wind turbines (AWT) with asynchronous generators (AG) in remote areas is one of the available solutions for power generation and electric power consumers.
It should be emphasized that despite the complexity of the circuits to control AWT random nature of change of wind speed and gusts it can lead to hypertension output of the generator mode. AWT with hypertension using pulsed converters (PC) to charge the batteries allows direct connection to a consumer that not only improves the working conditions of wind turbines, but also simplifies regulation voltage and frequency.
The work task design simulation models in parallel operation AWT AG to charge batteries during variable wind speeds and related this change duty cycle output signal PC. The development of the installation model is based on the software package Matlab / Simulink / SimPower Systems.
Studies have shown that in the case of the coincidence of voltage drops at the output of the converters (the ideal variant), the total charge current of the bidet is equal to the sum of currents from the generators. When a mismatch output voltage converters, as a result of various wind speeds in the area of the generator (real version), there should be a shift pulse charging current supply terminals on the batteries.
References
2. C. Chakraborty, S.N. Bhadra, A.K. Chattopadhyay, Excitation Requirements For Standalone Three Phase Induction Generator, IEEE Transactions on Energy Conversion, Vol. 13, No. 4, 1998, pp. 358–365.
3. Golovko V.M., Kohanevich V.P., Shikhailov N.A., Sandoval K., Donets A.M. Imitation Model For Analysis Of Parameters Of Autonomous Wind-Driven Installations With An Asynchronous Generator // Alternative energy and ecology, 2017, №4, P. 42–52.
4. Dominguez Garcia, Jose Luis, Modeling and Control of Squirrel Cage Induction Generator With Full Power Converter Applied To Windmills. Universitat Politecnica de Catalunya, Oulun Yliopisto, 2009.
5. Vasko P.F., Bryl A.A., Pekur P.P. Determination Of Technical Indicators Of Efficiency Of Wind Energy Utilization In Ukraine. Power engineering and electrification, 1995, №2, P. 48–51.
6. J. A. Barrado and R. Grino, Voltage and Frequency Control For A Self-Excited Induction Generator Using A Three-Phase Four-Wire Electronic Converter, 2006, 12th International Power Electronics and Motion Control Conference, Portoroz, 2006, pp. 1419–1424. DOI: 10.1109/EPEPEMC.2006.4778602
7. R. Bornet and S. Rajakaruna Self-Excited Induction Generator With Excellent Voltage and Frequency Control, in IEE Proceedings. Generation, Transmission and Distribution, vol. 145, No. 1, pp. 33–39, Jan 1998. DOI: 10.1049/ip-gtd:19981680.
8. B. Singh, S.S. Murthy, and S. Gupta, Analysis and Design of STATCOM-Based Voltage Regulator For Self-Excited Induction Generators, in IEEE Transactions on Energy Conversion, vol. 19, No. 4, pp. 783–790, Dec. 2004. DOI: 10.1109/TEC.2004.827710.
9. Vellapatchi Nayanar, Wind-Driven SEIG Supplying DC Microgrid Through A Single-Stage Power Converter. Nayanar Vellapatchi. Engineering Science and Technology, an International Journal. 19(2016) 1600–1607.
10. Kudrya S.O., Budko V.I., Pavlov V.B., Popov A.V, Pavlenko V.Y. Investigating The Work Of The Battery Charger From The Wind Turbine. Renewable energy, 2010, №4, P. 5–10.
11. Zachepa Y.V. Simulation of Transient Processes of Asynchronous Generator With Power Supply for DC Consumers. Collection of scientific works of Dneprodzerzhinsky State Technical University. Technical sciences, 2015, Vip. 1, P. 108–114.
12. Golovko V.M., Kokhanievich V.P., Shikhailov M.O. Sandoval K. Analysis Of Operating Modes Of An Autonomous Wind Power Plant With An Asynchronous Generator Using A Pulse Device For Charging Rechargeable Batteries based on simulation. Renewable Energy, 2017, №2, P. 63–74.
13. Golovko V.M., Sandoval K. Comparative analysis of experimental and simulation results of simulation of autonomous wind power plant with an asynchronous generator using a pulse device for charging rechargeable batteries // Power engineering and Automatics, 2017, №2 (32), P. 153–160.
14. A.s. 117122 Ukraine, IPC F03D 9/00, H02j 7/00. Battery charging device / V.M. Golovko, V.P. Kohanevich, M.O. Shikhailov, V.B. Pavlov, V.E. Pavlenko, K.P. Sandoval (Ukraine), №2017 01210, stat. 10.02.17, publ. on 06.12.17, Bull. №11.
Abstract views: 52 PDF Downloads: 46

This work is licensed under a Creative Commons Attribution 4.0 International License.